Skip to content
GitHubYouTubeInstagram

Hands-on courses built from our own robots’ CAD, code and match logs: read a little, then play with the labs.

A Kraken X60 motor, rendered from the CAD in our 2026 swerve module
Interactive course

Motors and Power

CIM to Kraken: what a motor does, what limits it, and how much the one you pick really changes.

  1. One motor’s curve
  2. Brushes, coils and FOC
  3. What a current limit takes away
  4. The battery is the limit
  5. Does the motor matter?
5 chapters · about 30 min →
Our 2026 offseason robot's launcher, rendered from its CAD
Interactive course

CTRE Control Modes

What a Talon FX can be asked to do, from a plain voltage to Motion Magic, told on our own launcher, elevator and swerve.

  1. Duty cycle, volts and amps
  2. Let the Talon close the loop
  3. Position control: PID and gravity
  4. Motion Magic: plan the move
  5. FOC and current limits
  6. Choosing the request
6 chapters · about 38 min →
The SDS MK5n swerve module from our 2026 robot, rendered from its CAD
Interactive course

Swerve Drive

What is inside a module, how four wheels make one motion, and how the robot knows where it is.

  1. Inside a swerve module
  2. Four wheels, one motion
  3. Odometry: dead reckoning
  4. Inside the gyro
  5. Field-centric vs robot-centric
5 chapters · about 29 min →
An AprilTag seen at an angle, with the detected outline, corners and pose axes drawn on it
Interactive course

Vision & AprilTags

How a camera, a Limelight or PhotonVision, and some geometry tell the robot where it is on the field.

  1. Why robots need vision
  2. Inside the camera
  3. Focus and calibration
  4. From corners to pose
  5. Getting it into the robot
  6. Match day
  7. Advanced: going faster
7 chapters · about 49 min →
Our 2026 TrenchBump-TrenchBump auto: its three PathPlanner paths and the robot at its start pose
Interactive course

Paths & Autonomous

How a robot drives itself for 20 seconds: paths, speed, following, events and reacting, on our own 2026 autos.

  1. What an auto is
  2. Shaping a path
  3. Speed along the path
  4. Following it
  5. Ways to build an auto
  6. Left, right, red and blue
  7. Doing things during auto
  8. Autos that react
8 chapters · about 56 min →
Our launcher speed from the Q36 match log as a thin line, with the stepped line a 10 Hz dashboard shows over it, and a row of five stops from the robot to replay
Interactive course

Telemetry, Logs and Replay

One launcher speed from the robot to a dashboard, into the log, and back out after the match, on our own Q36 log.

  1. NetworkTables: publish and subscribe
  2. What goes on the driver's screen
  3. What the robot writes down
  4. Reading a real match
  5. Replay
5 chapters · about 47 min →
A CTRE PDP 2.0, a SystemCore and a VH-109 radio, rendered from their makers' CAD
Interactive course

Control Systems

The wires, buses and networks between a driver-station button and a spinning motor.

  1. What is on the robot
  2. MAC and IP addresses
  3. What a switch does
  4. The CAN bus
  5. Power and wire gauge
5 chapters · about 32 min →