Resources
Training
Spectrum's student training curriculum — FRC basics, control systems, design and CAD, build, strategy, media, and awards.
Interactive Tutorials
Section titled “Interactive Tutorials”Hands-on courses built from our own robots’ CAD, code and match logs: read a little, then play with the labs.

Motors and Power
CIM to Kraken: what a motor does, what limits it, and how much the one you pick really changes.
- One motor’s curve
- Brushes, coils and FOC
- What a current limit takes away
- The battery is the limit
- Does the motor matter?

CTRE Control Modes
What a Talon FX can be asked to do, from a plain voltage to Motion Magic, told on our own launcher, elevator and swerve.
- Duty cycle, volts and amps
- Let the Talon close the loop
- Position control: PID and gravity
- Motion Magic: plan the move
- FOC and current limits
- Choosing the request

Swerve Drive
What is inside a module, how four wheels make one motion, and how the robot knows where it is.
- Inside a swerve module
- Four wheels, one motion
- Odometry: dead reckoning
- Inside the gyro
- Field-centric vs robot-centric

Vision & AprilTags
How a camera, a Limelight or PhotonVision, and some geometry tell the robot where it is on the field.
- Why robots need vision
- Inside the camera
- Focus and calibration
- From corners to pose
- Getting it into the robot
- Match day
- Advanced: going faster

Paths & Autonomous
How a robot drives itself for 20 seconds: paths, speed, following, events and reacting, on our own 2026 autos.
- What an auto is
- Shaping a path
- Speed along the path
- Following it
- Ways to build an auto
- Left, right, red and blue
- Doing things during auto
- Autos that react

Telemetry, Logs and Replay
One launcher speed from the robot to a dashboard, into the log, and back out after the match, on our own Q36 log.
- NetworkTables: publish and subscribe
- What goes on the driver's screen
- What the robot writes down
- Reading a real match
- Replay

Control Systems
The wires, buses and networks between a driver-station button and a spinning motor.
- What is on the robot
- MAC and IP addresses
- What a switch does
- The CAN bus
- Power and wire gauge
